Molti di voi avranno notato che al primo avvio il Display Code della mobo (E760) non rimane fisso su FF...
Se anche voi avete questo "problema" basta che disabilitate la voce "P80 Show CPU Temp"
Consiglio su come impostare il Bios (nel mio caso con il Raid0):
Advanced Bios Features:
- Hard Disk boot Priority> 1.SCSI-0 : Intel Volume0 (RAID Mode)
- First boot Device : Hard Disk
- Second boot Device : Disabled
- Third boot Device : Disabled
- Boot other device : Enabled
- Boot Up Numlock Status : ON
- Security Option : Setup
- Full Screen Logo Show : Enabled/Disabled
Integrated Peripherals:
- Onboard PATA/SATA Device: > RAID (RAID Mode)
- JMB 362 SATA Controller : Disabled
- JMB 363 SATA/PATA Controller : Disabled
- JMB 363 Mode : Raid (RAID Mode)
- JMB 362 Mode : Raid (RAID Mode)
Onboard Device:
Realtek GigaLan 1: Disabled/Enabled
Realtek GigaLan 2: Disabled/Enabled
PE4 Slot: Disabled
Realtek Lan PXE Boot Rom: Disabled
TI 1394 Setting: Disabled
High Definition Audio: Enabled
P80 Show CPU temp: Disabled
Power Management Setup:
- ACPI Function : enabled
- ACPI Sospend Type : S1 (POS)
- Soft-Off by PWP-BTTN : Instant Off
- Wake-Up by PCI Card : Enabled
- Resume Alarm : Disabled
- Power On Function : Disabled
- PWRON After PWR-Fail : Off
PnP/PCI Configurations:
- Init Display First : PCI-E
- Reset Configuration Data : Disabled
- Resources Controlled by : Disabled
- PCI/VGA Palette Snoop : Disabled
- INT Pin 1/8 Assignment : Auto
- MAXIMUM PAYload Size : 128
INTRODUZIONE OVERCLOCK
BIOS: E760S61J
RS @191x21
Core i7 920 D0
gskill Trident 1600MHz Cas 6
BIOS TEMPLATE
Frequency/Voltage Control
- DUMMY OC : Disabled
- Extreme Cooling : Disabled
- CPU Clock Ratio : 20x (21x Turbo ON)
- CPU Host Frequency (MHz) : 191
- MCH STRAP : Auto
- CPU UnCore Frequency : 3061 (MHz) 16x
- CPU Clock Skew : 0 ps
- Spread Spectrum : Disabled
- PCIE Frequency (MHz) : 101 MHz
- OC Recovery : Disabled
CPU Feature
- Intel Speed Step : Disabled
- Turbo Mode Function : Enabled
- CxE Function : Disabled
- Execute Disabled Bit : Disabled
- Virtualization Technology : Disabled
Logical Processor Setting
- Intel HD Technology : Enabled
- Active Processor Core : ALL
QPI Controller Setting
- QPI Controll Setting : Enabled
- QPI Link Fast Mode : Enabled
- QPI Frequency Selection : 4.800GT/s
Memory Feature
- Memory SPD : Standard 1
- Memory Control Setting : Enabled
- Memory Frequency : 2:8 - 1530Mhz
- Channel Interleave Setting : 6 way
- Rank Interleave Setting : 4 way
- Memory low gap : 2,5GB
Voltage Control
- EVGA VDrop Control : without VDroop
- CPU Vcore : 1.20625v (Dipende dalla vostra CPU)
- CPU VTT Voltage : +75mv (+100mv)
- CPU PLL Vcore : 1.800v
- IOH PLL Vcore : 1.800v (1.820v)
- QPI PLL Vcore : 1.300v
- DIMM Voltage : 1.610v (1.650)
- DIMM DQ VREF : +0mv
- IOH Vcore : 1.200v
- IOH/ICH I/0 Voltage : 1.550v
- ICH Vcore : 1.050v
- VTT PWM Frequency : 370KHz
- CPU PWM Frequency : 940KHz
- CPU Impedance : Less
- QPI Signal Compensation : Less
BIOS: E760S61J
RS @201x21
Core i7 920 D0
gskill Trident 1600MHz Cas 6
BIOS TEMPLATE
Frequency/Voltage Control
- DUMMY OC : Disabled
- Extreme Cooling : Disabled
- CPU Clock Ratio : 20x (21x Turbo ON)
- CPU Host Frequency (MHz) : 201
- MCH STRAP : Auto
- CPU UnCore Frequency : 3221 (MHz) 16x
- CPU Clock Skew : 0 ps
- Spread Spectrum : Disabled
- PCIE Frequency (MHz) : 101 MHz
- OC Recovery : Disabled
CPU Feature
- Intel Speed Step : Disabled
- Turbo Mode Function : Enabled
- CxE Function : Disabled
- Execute Disabled Bit : Disabled
- Virtualization Technology : Disabled
Logical Processor Setting
- Intel HD Technology : Enabled
- Active Processor Core : ALL
QPI Controller Setting
- QPI Controll Setting : Enabled
- QPI Link Fast Mode : Enabled
- QPI Frequency Selection : 4.800GT/s
Memory Feature
- Memory SPD : Standard 1
- Memory Control Setting : Enabled
- Memory Frequency : 2:8 - 1604Mhz
- Channel Interleave Setting : 6 way
- Rank Interleave Setting : 4 way
- Memory low gap : 2,5GB
Voltage Control
- EVGA VDrop Control : without VDroop
- CPU Vcore : 1.26875v (Dipende dalla vostra CPU)
- CPU VTT Voltage : +100mv
- CPU PLL Vcore : 1.800v
- IOH PLL Vcore : 1.800v (1.820v)
- QPI PLL Vcore : 1.300v
- DIMM Voltage : 1.650v
- DIMM DQ VREF : +0mv
- IOH Vcore : 1.200v
- IOH/ICH I/0 Voltage : 1.550v
- ICH Vcore : 1.050v
- VTT PWM Frequency : 370KHz
- CPU PWM Frequency : 940KHz
- CPU Impedance : Less
- QPI Signal Compensation : Less